Bimba Ultra Slide Rodless Cylinder User Manual download pdf

Bimba Ultran

Slide Rodless Cylinder

Repair Instructions

CAUTION!

The magnets used in the Ultran product line are of an extremely high

strength and brittle material. Caution should be used in handling these

magnets.

If the magnets are cracked due to impact fractures during the repair

process, they will repel each other and y apart.

During the repair of the product, be sure your ngers do not get between

the piston and the carriage. The magnets on both these parts will attract

each other and could cause injury.

NOTES

Cleanliness of the internal parts is imperative for maximum life of the slide unit.•

Parts that have been repaired should be covered or bagged until needed for •

nished assembly.

Any high grade of bearing grease should be used for lubrication purposes.•

Tools required:

knife or wire cutters

hex driver

arbor press

screwdriver

retaining ring pliers

torque wrench

plastic bags or clean containers to hold parts during the repair

lubricant

NOTE on Arbor Press: Using an arbor press is the safest and preferred way to

perform some of the operations in these instructions. Pressing through the body’s

length is necessary, so the arbor press must have its table a distance from the oor

that is equal to or greater than the stroke of the cylinder. A proper repair is unlikely

if these warnings are not followed.

1 2 3 4

Summary of Contents

Page 1 - Repair Instructions

Bimba Ultran® Slide Rodless Cylinder Repair InstructionsCAUTION!The magnets used in the Ultran product line are of an extremely high strength and brit

Page 2 - SLIDE REPAIR INSTRUCTIONS

Figure 1:Figure 2:Refer to Figure 1 for Steps 1–71. Remove air pressure and ttings.2. Wipe down and clean the unit.3. Remove the four cap scre

Page 3 - Refer to Figure 5 for Step 22

Note: The Ultran guide shaft bearings were upgraded in the second half of 2000. All new repair kits shipped after September 2000 will c

Page 4 - Figure 6:

Figure 6:Bore SizeTorque ft–lb (N–m)Bore SizeTorque ft–lb (N–m)007 (8mm) 1.6 (2.17) 09 (27mm) 20.1 (27.25)01 (12mm) 2.1 (2.85) 12 (32mm) 50.8 (68.9)02

Comments to this Manuals

No comments

Bimba Ultra Slide Rodless Cylinder User Manual

Browse online or download User Manual for Measuring instruments Bimba Ultra Slide Rodless Cylinder. Bimba Ultra Slide Rodless Cylinder User Manual

Summary of Contents

Comments to this Manuals